Think Fencing has been manufacturing PVC composite fencing for over a decade in Australia and has tested its fencing systems in the harshest of conditions. Think Fencing employs modern technologies and polymers to create the best fencing systems possible, and has tested them to in excess of 50 years. If a manufacturing defect is found within the life of the product Think Fencing will replace it. More information on Think Fencing’s Manufacturers warranty is available on www.thinkfencing.com.au
First mark out the correct post spacing. Next augur or dig a hole 300mm wide by 650mm deep. Fill the hole with a wet mix concrete mix and push the post into the concrete mix allowing the mix to flow up into the inside of the post.
First mark out the correct Gatepost location. Place the post in the hole and mark out the hinge location. Fit the hinge to the post making sure you have sufficient adjustment to correctly position the gate once the post is set. Place the post in the hole and fit the rails into the post. Before the rails are slid into the post block the ends of the rails with adhesive tape. Brace the post if required. Drive a single 12mm Steel Re-enforcing bar through the centre of the post into the soil then core fill the post with a wet mix concrete. After the concrete has set you can bolt the gate to the hinge.
All of Think Fencing’s coloured products are made from a PVC acrylic composite, the PVC makes up the structure of the profile and the Acrylic capping layer provides the colour. This is very important as coloured PVC that is not capped will fade very fast. Whilst we use the best products available today a 10-year-old fence will not look like a 10-week-old fence. (It will however look significantly better than a 10-year-old timber fence)
Think Fencing has a dedicated design and fabrication division that is equipped to assist you with all aspects of design and manufacture. If you have an idea we can make it a reality. Just send a basic sketch or an image of the style of fence you are trying to replicate. (We can also match colour-Subject to Minimum orders)
Yes, Think Fencing can make almost any gate design you want, Swing gates can be made up-to 2.4m each panel and sliding gates can be made up-to 6m long! All gates come with hardware made by D&D Technologies and are also 100% Australian made.